Learn Software and Hardware Tools … Archive of Older Development Tools MPLAB® ICD 3 (DV164035) MPLAB ICD 3 Setup
The MPLAB ICD 3 is first connected to a USB port on your computer and then to the development board. To do so, follow these steps:
Connect the USB cable to the ICD 3.
Back to Top
Connect the USB cable to a USB port on your computer.
Back to Top
Install the PIC® Microcontroller on your development board.
Back to Top
Connect the RJ11 cable to the ICD 3.
Back to Top
Connect the ICD 3 RJ11 cable to the programming port on your development board.
Back to Top
Connect power to your development board.
Note: The ICD 3 can power a development board but we recommend you power the board separately until you are familiar with the tool and the limitations of providing power through the ICD 3.
Back to Top
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.
